Allyanz Electronics, Semiconductors, Integrated Modules, Displays. Manufacturers Representative & Distributor Australia, NZ & South East Asia. Tel: +61.3.9759 5949
Micrel Introduces 85V Half Bridge MOSFET Drivers
Micrel Introduces 85V Half Bridge MOSFET Drivers with Integrated Bootstrap Diode, Widest Programmable Gate Drive Range
Solution Offers Up To 40 Percent Longer Operating Time Over Existing Devices for Battery Powered Applications
Micrel Inc., industry leader in high-performance Linear and Power solutions, LAN and timing and communications solutions, has released the new MIC4604, a 85V Half Bridge MOSFET driver that features an integrated 85V Bootstrap diode and one of the widest programmable gate drive ranges (5.5V to 16V) in the industry.
These features make the MIC4604 an ideal solution for the industry’s most demanding battery operated motor applications including Communications (HF) Radios, Power tools and Power DC/AC inverters.
Please contact Allyanz today for more details or evaluation samples of the MIC4604.
Micrel Announces New Enhanced 2-Port Ethernet Controller
Micrel Announces New Enhanced 2-Port Ethernet Controller with 8/16-bit host interface – KSZ8852HLEWC
The KSZ8852 family from Micrel is an enhanced version of the current KSZ8842 Ethernet Controller family providing the following advantages:
- Lower power – total <300mW typical
- EEE (Energy Efficient Ethernet) support
- On-Chip Termination Resistors
- Smaller package – 64-pin LQFP (10mm x 10mm)
- Increased traffic throughput
- Improved ESD >4kV
- Extended temperature range -40oC to +105oC
Please contact Allyanz today to discuss further details, or organise samples for the new KSZ8842 from Micrel.
Versatile New DC/DC Buck HBLED Driver from ISSI: IS31LT3360
The IS31LT3360 is a simple and a flexible LED driver being used in a wide range of applications that include alarms, pool lighting and flashlights.
This is a versatile new LED driver from ISSI which requires a very low BOM count making it simple to integrate into a variety of applications.
A continuous mode inductive driver available in a space saving SOT89-5 package, the IS31LT3360 integrates the output FET switch and the current sense circuit; requiring only a sense resistor and an external inductor to set the LED output current (up to 1200mA).
The IS31LT3360 is a DC/DC buck converter operating at a 1Mhz switching frequency to efficiently (up to 98%) drive one or more series connected LEDs from a voltage source higher than the LED voltage.
Please contact Allyanz today for more details or evaluation samples of the IS31LT3360.
Swissbit now shipping INDUSTRIAL 2GB-8GB DDR3L SO-DIMMs
Swissbit has released new members of its INDUSTRIAL family of DDR3 SODIMMs compatible with the JEDEC DDR3L standard running at 1.35V. DDR3L will allow an up to 15% reduction in power consumption over DDR3.
With the introduction of 3x and 2x nm DRAM technology, the modules are able to run at lower external supply voltage than the standard 1.50V. Foreseeing this evolution, JEDEC as the standardization group for DRAM components has developed a new standard for 1.35V operation called DDR3L (L standing for low voltage). Systems supporting this feature benefit from a reduced supply voltage and decreased power consumption. This lowers the self heating, and thermal margins while increasing system reliability.
Swissbit now offers DDR3L SO-DIMMs and DDR3L SO-UDIMMs (72b SO-DIMMs) with 2GB to 8GB densities, and speed grades up to DDR3L-1600.
The modules are available in both commercial 0oC to +85oC (TCase) and industrial -40oC to +95oC (TCase) temperature grades and with ECC (error correction support) on demand.
Please contact Allyanz today for more details or evaluation samples of the Swissbit DDR3L SO-DIMMs.